FAQ-1684
IP CONFIG ARP CMD

 

COMM ONE FAQ-1684

Use IPCONFIG & ARP Commands to IP's in Use
   

When you are setting up IP Call Capture for Comm One it is occasionally difficult to see if your computer can see your phone system to capture calls.  This command shows you all IP Addresses in use and can be valuable in troubleshooting network problems.

  1. Select START then RUN

  2. Type CMD to start the command line prompt

  3. At the command prompt type the following commands

         ipconfig
         ping 127.0.0.1
         arp -a

     

  4. A list of IP Addresses in use on your network will be displayed.

Comm One Call Accounting Software

Technical Support

PO Box 759 | 1390 E Meadow Valley Dr

Draper, UT  84020

(800) 771-9182

support@commone.com

FAQ-1684 Use IPCONFIG with ARP

Posted: 02/02/2017

Updated: 06/05/2020

Author: Comm One Technical Support